Denon DVD-2800 Operating Instructions Manual page 12

ENGLISH
2 Sound output from the DVD-2800's digital audio output connectors
Audio recording format
DVD video
DVD audio
(video part only)
Video CD
Music CD
MP3 CD
• Linear PCM audio is the signal recording format used for music CDs.
While the signals are recorded at 44.1 kHz/16 bit for music CDs, for DVDs they are recorded at 48 kHz/16 bit to 96 kHz/24 bit, providing
higher sound quality than music CDs.
• When "OFF" is selected, digital signals are not output from the digital audio output at this time.
(4) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See
page 43.)
• "DIGITAL OUT" → "PCM"
"LPCM SELECT" → "ON"
Playing DVDs with incorrect settings may result noise that could
damage your ears or the speakers.
" "
• Set the TV TYPE in
your TV's video format. When the TV is NTSC formated, set to
NTSC. (See page 41.)
B
12
Digital out : Normal
Dolby Digital
Digital out : PCM conversion
Digital out : Normal
DTS
Digital out : PCM conversion
LPCM conversion mode : OFF
48 kHz
LPCM conversion mode : ON
96 kHz LPCM conversion mode : ON
CP : ON LPCM conversion mode : OFF
CP : OFF LPCM conversion mode : OFF
MPEG 1
Linear PCM
MP 3
" " " "
VIDEO SETUP in SETUP comply with
8 9
Digital audio input connector (OPTICAL)
Digital audio input connector (COAXIAL)
Refer to
Settings
page
42
43
TV
AUDIO DIGITAL OUT
OUT (PCM/BITSTREAM)
OPTICAL COAXIAL
L
R
Digital audio data output
Dolby Digital bitstream
2 channels PCM data (48 kHz/16bit)
DTS bitstream
No output data
48 kHz/16 ~24 bit PCM
48 kHz/16 bit PCM
48 kHz/16 bit PCM
No output data (when copy-protected)
96 kHz PCM (when not copy-protected)
44.1 kHz/16 bit PCM
44.1 kHz/16 bit PCM
32 ~ 48 kHz/16 bit PCM
VIDEO IN
DVD-2800
COMPONENT
VIDEOOUT
VIDEO
Y
OUT
P /C
B B
P /C
R R
S-VIDEO
OUT