Useful Tools; Dimensions; Installation Area - Bosch Vision 300 Operating And Installation Instructions

The accessory parts bag contains:
1. Covers to be placed over the holes
for the transport bolts (after
removing the transport bolts
during washer installation).
2. Wrench for leveling.
3. Clamp for drain hose.
On the back of the washer:
1. power cord with plug
2. hot and cold water connections
3. 4 shipping bolts

Useful tools

The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench13 mm
3. Closed wrench 13 mm
8
Downloaded from www.Manualslib.com
DO NOT push against the washer
door glass. Risk of breakage!

Dimensions

a = 27.0 in. (68.7 cm)
b = 29.7 in. (75.4 cm)
c = 36.8 in. (93.5 cm) (minimum)*
37.8 in. (96.2 cm) (maximum)*
d = 20.7 in. (52.5 cm)
e = 49.8 in. (126.3 cm)
* height of appliance depends upon
extension of height-adjustable feet.
Minimum height is with feet turned all
the way in, against the bottom of the
washer. Maximum height is with feet
extended as far as permitted (must
leave thread of screw engaged
enough for foot to be stable (1/4 inch /
6.4 mm) when extended).
Door opening angle 160°
Approx. weight = 220 lbs (100 kg)
manuals search engine
NOTICE

Installation area

,
WARNING
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of the washer walking" will be
influenced by the structure and
stability of the floor surface where
the appliance is installed.
Soft floor surfaces, such as
q
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
If the washing machine is to be installed
on a weak wood floor, consider the
following:
Screw a section of water-resistant
q
plywood (at least 3/4" thick) to the
floor. The plywood should be
sized to fit the footprint of the
washer, approximately 27" wide x
29.7" deep, or 54" wide x 29.7"
deep to extend underneath both
the washer and the dryer for best
results and even height of the
appliances.
Secure the feet of the washing
q
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).