Internal Connectors - mATX AIMB-562 Series User Manual

Intel core 2 duo / pentium d / pentium 4 / celeron matx main board
Table of Contents

Advertisement

1.10.2

Internal connectors

1.
Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using an FDD cable with a covered Pin 5.
Floppy disk drive connector
2.
Primary IDE connector (40-1 pin PRI_IDE)
These connectors are for Ultra DMA 133/100/66 signal cables. There are three
interfaces on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue interface into the motherboard's IDE connector, then select one
of the following modes to configure your hard disk drive(s).
Cable Select Mode - use this mode to select the operating mode by
cable connectors.
No. of drives
1
2
Jumper Select Mode - use this mode to select the operating mode by
hard disk drive jumper.
No. of drives
1
2
AIMB-562
Drive type
Drive jumper
With OS
With OS
Cable select
Without OS
Drive type
Drive jumper
With OS
Master
With OS
Master
Without OS
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
Cable connector
Cable connector
black or gray
Slave
black
black
gray
1-25

Advertisement

Table of Contents
loading

Table of Contents