Mounting The Net Base - Honeywell Dolphin 70e Black User Manual

Troubleshooting
If the items on the Ethernet configuration screen are grayed out and not accessible, verify the base has
power, the Ethernet cable is undamaged and properly installed to the base, there is an active network
signal over the Ethernet cable, and the terminal is properly docked in the base.
Ethernet Configuration Settings
Instead of using the default DHCP assigned IP address, the Dolphin terminal can be configured to use a
statically assigned IP address.
1. Touch > Settings
2. Select Ethernet configuration, again.
3. Select Static IP under Connection Type , then input the IP address and any additional information
based on your network configuration.
4. Touch Save.
Ethernet Proxy Settings
To set up a proxy to use when accessing your network with Ethernet:
1. Touch > Settings
2. Input the Proxy host name and Proxy port. If required, designate when to bypass the proxy.
3. Select Done.
Displaying the Net Base and Terminal IP Address
Once the Dolphin terminal has been successfully connected to the network through Net Base, the termi-
nal uses the Net Base IP address. The IP address can be used by any application on the Dolphin termi-
nal.
Touch > Settings

Mounting the Net Base

Set the Net Base on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be
sure to provide enough workspace with good lighting for the user to view and operate the Dolphin
terminal while it is in the Net Base. When choosing a location, bear in mind that the mounting location
must allow users to see the LEDs and provide easy access to the terminal wells, the Ethernet ports, and
the power jack.
13 - 6
> Ethernet configuration.
> Ethernet proxy settings.
> About Phone > Status to view the assigned IP Address.