Toshiba RAS-M10PKVP-E Service Manual page 122

12-1-2. Fixing Frame Assembly
1) Detach the two air filters.
2) Disconnect the plasma ion charger connector
and the earth lead (black). (The earth lead is
connected to the heat exchanger with a screw.)
3) Remove the two screws securing the fixing
frame to the rear of the indoor unit.
Fixing frame
Air filter
Connector
(Plasma ion charger)
Fig. 12-1-4
4) While turning the upper part of the fixing frame
to the front, release the front claw of the fixing
frame from the rear of the indoor unit.
Claws (Upper part)
Fig. 12-1-5
Screws
Earth screw
(Plasma ion charger)
Claws (Front part)
12-1-3. Electric Parts Cover Detached
1) Perform work of Detachment 12-1-1. Removing
the Front Panel and Moving Panel.
2) Remove the screw beside the screw that se-
cures the electric parts box assembly.
3) Remove the connector cover screws and detach
the connector cover.
4) While pushing the claw of the lead wire cover in
the direction shown in the figure, lift the bottom
of the lead wire cover to detach it.
5) Disconnect the connectors below.
• Louver motor connector (24P) for louver
• Fan motor connector (5P)
• Louver motor connector (5P) for movable panel
• Minus ion charger connector (4P)
6) Remove the motor base assembly by releasing
the claw.
7) Remove the earth screw, TC sensor, and TCj
sensor.
When attaching the electric parts assembly
• Insert the projection at the rear of the indoor unit
into the upper hole in the electric parts assembly.
• Check that the fan motor lead wires are con-
nected as shown in the figure.
When attaching the motor base assembly
• Before attaching the motor base assembly,
connect the earth wire and install the TC and TCj
sensors.
• Insert the bottom of the motor base assembly into
the portion shown in the figure.
• Insert the motor cover projection into the hole in
the right side panel of the motor base assembly.
– 122 –
CAUTION