Before Threading - Husqvarna HUSKYLOCK 1002 Handbook

Before threading...
1) Turn
off
the main power switch
for
safety.
Turn on the main power switch when
referring to the LCD
in order to thread the needle, but disconnect the loot con
trol from the machine as a safety measure.
2)
Raise the presser foot by using presser foot lever.
When the presser foot is raised, the two thread tension discs
in the thread tension control panel are released so that
thread passes freely between them. Otherwise thread ten
sion may not be correct.
When threading the needle, always be sure to lift the presser
and also take care to thread in the proper order,
J
3) Set the needle bar in its highest position by turning the hand-
wheel toward you.
Turn the handwheel to find the easiest position br threading,
and then thread the upper looper thread, lower looper
thread, right needle thiead and then the lett needle thread or
double chain stitch needle thread (5-thread model only) in
that order.
Threading order
Thread in the following
order:
H Upper looper thread (green)
2) Lower looper thread (blue)
3) Double chain stitch looper thread (purple) in case of S thread stitch or double chain stitch
4, Right needle thread (red)
5 Left needle thread or double
(ham needle thread )vellow
Bce
ause the left thread tension dial (yellow) is used for either the left needle or the double chain stitch needle,
needles will iiever be used at the same time.
I
h
read ienson
d
sc
,
i
4
/
riizzzz
-
14
-