To Page The Handset; To Lock The Keypad; Using Your Cordless On A Pabx; Redial - Linkcom Link 680 DECT Instruction Manual

Cordless dect gap
Table of Contents

Advertisement

Available languages

Available languages

This function is useful if you can't find your handset.
On the base unit press and release the
To stop the handset ringing, on the handset press any button or numbered key.
To lock the handset's keypad so that no buttons can be pressed.
To block the handset keypad, while handset is idle press
a confirmation beep and
To unlock the keypad, press
PAUSE FUNCTION
If you have a PABX connection you need to pause for a few seconds between dialling the system code and the
actual phone number. To pause, press the
This is the flash key, press it during the line is engaged to send the flash signal.
To turn the ringer temporarily off, when the handset is idle press and hold for a few seconds the button, the
symbol
will appear on the display.
To turn the ringer back on, press and hold again the button
display.
IMPORTANT: with this function active only the base rings when receiving a call, while the handset only shows
a symbol on the display.
Press the
button and hold 3 second until you hear a beep sound.
The display will show "S" for a short flash time at 100ms.
To come back to a 270ms flash time, do the same again, the display will show "L" for a long flash time
DECT GAP Link 680

6.11 TO PAGE THE HANDSET

button. The handset rings with a special tone

6.12 TO LOCK THE KEYPAD

appears on the display.
, again and hold it until

6.13 USING YOUR CORDLESS ON A PABX

button and a dash "-" will appear on the display.

6.14 REDIAL

6.15 TURNING RINGER TEMPORARILY OFF

6.16 SWITCHING FLASH TIME

and hold it for a few seconds; until you hear
disappears from the display.
, the symbol,
will disappear from the
13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Link 680 DECT and is the answer not in the manual?

Table of Contents