Hitachi G 10SR3 Technical Data And Service Manual page 13

(4) When installing the Stator [11] into the Housing Ass'y [37], insert it while taking care of the placement of the
internal wires of the Stator [11] as indicated in Fig. 8.
Connect the four internal wires of Stator [11] with the parts indicated in Fig. 8.
Connect the internal wires correctly as shown in Fig. 9.
Connect to the Carbon Brush
(Auto Stop Type) (1 Pair) [39]
(Side B).
Connect to the Switch (1P Solder Type) [42].
(When using the Noise Suppressor [46],
connect to the Switch (1P Solder Type) [42]
with the Terminal [45] of the Noise Suppressor
[46].)
Connect to the Carbon Brush
(Auto Stop Type) (1 Pair) [39] (Side A).
Fig. 8
Noise suppressor is provided.
Fig. 9
--- 10 ---
Connect to the Cord [52]
with the Pillar Terminal [41].
Side A
Side B