d) Remove any adjusting key or wrench before GENERAL SAFETY RULES turning the power tool on. A wrench or a key left attached to a rotating part WARNING! of the power tool may result in personal injury. Read all instructions e) Do not overreach.
j) Hold power tool by insulated gripping surfaces SAFETY WARNINGS COMMON FOR only, when performing an operation where the GRINDING OPERATIONS cutting accessory may contact hidden wiring or its own cord. a) This power tool is intended to function as a grinder. Cutting accessory contacting a”live”...
Corners, sharp edges or bouncing have a tendency e) Do not use worn down wheels from larger power to snag the rotating accessory and cause loss of tools. control or kickback. Wheel intended for larger power tool is not suitable e) Do not attach a saw chain woodcarving blade or for the higher speed of a smaller tool and may toothed saw blade.
When release the switch to OFF position, push the shown in Fig. 1, the machine should be held at an rear part of slide knob. angle of 15° – 30° so that the external edge of the 3. Extension cord depressed center wheel contacts the material at an When the work area is removed from the power optimum angle.
3. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement on this tool should ONLY be performed by a Hitachi Authorized Service Center. 4. Replacing supply cord If the supply cord of Tool is damaged, the Tool must be returned to Hitachi Authorized Service Center for the cord to be replaced.
Page 16
Hitachi Koki Co., Ltd. Code No. C99159824 F Printed in China...