Page 1
DC TO AC POWER INVERTER POWER : 300W PI300M for input voltage 12V PI30024 for input voltage 24V ATTENTION – OPGELET - ACHTUNG OVERLOADING THIS DEVICE OR CONNECTING IT WITH AN INDUCTIVE LOAD (e.g. refrigerator, fan, drill) WILL DAMAGE IT AND AUTOMATICALLY VOID THE WARRANTY !! HET TOESTEL ZAL WORDEN BESCHADIGD INDIEN U HET OVERBELAST OF ER EEN INDUCTIEVE BELASTING (vb.
Page 2
When connected to an appliance, remember to turn on the inverter before turning on the appliance. If the buzzer sounds during operation, this indicates that the battery voltage is very low and that the inverter will be disconnected in 5 minutes. "Turn on" "Turn on" secondly firstly PI300M & PI30024 v2...
Page 3
VOID THE WARRANTY AND MAY DAMAGE THE INVERTER. The battery's voltage must never exceed 15VDC (30VDC for a 24V inverter). CONNECTING THE INVERTER TO A DC POWER SOURCE GREATER THAN 15VDC (30VDC) WILL VOID THE WARRANTY AND MAY DAMAGE THE INVERTER. PI300M & PI30024 v2...
Page 4
NOTE : The earthing terminal of the AC outlet is connected to the neutral terminal. This is the same as with a standard household power point where the neutral connection is bonded to earth and there is no voltage between the two. PI300M & PI30024 v2...
Page 5
IMPORTANT ! During operation, make sure the fan keeps revolving. Check the inverter for possible malfunctions if the fan does not work when this unit is being used. Make sure the fan is not blocked in order to avoid poor ventilation. GOOD PI300M & PI30024 v2...
Page 6
(B) Not exposed to direct sunlight or any other heat source (C) Inaccessible to children (D) Safe from water/moisture, oil or grease (E) Safe from any flammable substance If the inverter is connected in the wrong way, this will void the warranty. PI300M & PI30024 v2...
Page 7
WARNING : DO NOT DISASSEMBLE THIS UNIT AS DOING SO MAY CAUSE HAZARDOUS VOLTAGES !! RETURN THIS UNIT TO THE DEALER IN CASE OF TROUBLE !! DO NOT CONNECT ANY INDUCTIVE LOADS WITH THIS DEVICE !! PI300M & PI30024 v2...
Need help?
Do you have a question about the PI300M and is the answer not in the manual?
Questions and answers