Security Authentication; To Deactivate The Security Lock; Setting An Ip Address And Communication Speed; Obtaining An Ip Address Automatically (Dhcp) - Sony FWD-40LX1 Operating Instructions Manual

3
Enter the password again for re-confirmation.
Re-enter new password key.
Be sure to remember this password.
Use : Cancel : Other key
MENU ENTER
The setting is finished when the following
message appears.
INITIAL SETUP/INFORMATION
Language: English
Color System: Auto
Auto Shut Off: Off
Security Lock: On
Information
All Reset
Security Lock enabled!
Select Set
ENTER
If "Invalid password!" appears on the menu
screen, start the procedure again from Step 1.
INITIAL SETUP/INFORMATION
Language: English
Color System: Auto
Auto Shut Off: Off
Security Lock: Off
Information
All Reset
Invalid password!
Select Set ENTER
4
After completing the process described above,
turn off the display unit and unplug the power
cord to make the setting valid.
The Security Lock becomes activated and the
dialog box prompting you to enter the password
appears when you turn on the display unit next
time.

Security authentication

Enter the password that is set for the display unit
when the dialog box prompting you to enter the
password appears.
If you enter the wrong password three times, you
cannot operate the display unit any further. In this
situation, press the 1POWER switch to turn off the
display unit.

To deactivate the Security Lock

Press MENU and set "Security Lock" to "Off" in the
INITIAL SETUP/INFORMATION menu.
Setting the Security Lock / Setting an IP address and communication speed
Exit
MENU
Exit MENU
Setting an IP address and
communication speed
When an optional adaptor with communication
function such as BKM-FW32 or BKM-FW50 is
installed into the OPTION1 slot in the display unit, set
an IP address and communication speed to control the
display unit via the network.
Note
Setting of an IP address and a communication speed is
completed by selecting "Execute" and pressing ENTER.
When the setting is completed properly, "Done" will
be displayed.
When the setting is not completed properly, an error
code will be displayed. In such a situation, confirm
the setting values and set up again.
Obtaining an IP address
automatically (DHCP)
1
Press MENU.
The main menu appears on the screen.
PICTURE/SOUND CONTROL
Picture Mode: Vivid
Adjust Picture
Adjust Sound
Select Set
ENTER
2
Select "INITIAL SETUP/INFORMATION" with
M/m and press ENTER.
The INITIAL SETUP/INFORMATION menu
appears on the screen.
INITIAL SETUP/INFORMATION
Language: English
Color System: Auto
Auto Shut Off: Off
Security Lock: Off
Information
All Reset
IP Address Setup
Speed Setup
Select Set
ENTER
Exit
MENU
Exit
MENU
39
(GB)