Connecting Digi-Frame™ To The Power Supply; Inserting Memory Storage Cards; Compactflash™ Cards - Digi-Frame DF-560 User Manual

Connecting Digi-Frame™ to the Power Supply:
The Digi-Frame™ runs on AC power from an ordinary wall outlet. Use only
the Supplied Digi-Frame™ external Power Supply connected to a grounded
(three prong) outlet. Other power adapters may cause damage to the Digi-
Frame™.
Before connecting the power supply make sure the Digi-Frame™ power
switch is in the off position.
Connect the External Power Supply to the Power Supply jack on the back
of the Digi-Frame™. Be sure to match the arrow on the plug to the arrow
on the case before pressing the plug into the receptacle. The plug should
be inserted deeply into the case, because the Power Supply Jack is recessed
inside the Digi-Frame™.
Then plug the External Power Supply wall plug into a standard 100-240
VAC 60 Hz source
10

Inserting Memory Storage Cards:

The Digi-Frame™ 560 is designed to read either SmartMedia™ or Compact
Flash memory storage cards. Turn the Digi-Frame™ off before inserting or
removing Memory Storage Cards.
Both kinds of cards may be inserted into the Digi-Frame™ at the same
time.
IMPORTANT:
The Digi-Frame™ will only recognize digital pictures stored in the JPEG
format. Digital Pictures stored in other formats will be ignored by the
Digi-Frame™.
If no memory storage cards are inserted, or if no pictures are found on the
card, the Digi-Frame™ it will wait a few moments, then automatically switch
to Self-Demonstration mode.
CompactFlash™ Cards:
To insert the CompactFlash™ card:
Make sure the Digi-Frame™ is off.
Gently slide the card into the CompactFlash™ slot. The card only goes in
one way. Do not force the card into the slot.
To remove the CompactFlash™ card:
Make sure the Digi-Frame™ is off.
Press the eject lever into the Digi-Frame™, this will dislodge the
CompactFlash™ card. Once the lever is pressed inside the body of the Digi-
Frame™, gently pull the card free.
11