Table of Contents
Advertisement
SuperSat Series Owner's Manual
Attaching Center Channel Feet (SuperSat 3C & 50C Only)
If you going to set you SuperSat Center Speaker on a table or bookshelf, install the included Adjustable Center
Stand Foot as follows:
Tools required:
Parts included SuperSat 3C:
Parts included SuperSat 50C: Two Adjustable Feet
Instructions:
1.
Carefully lay the SuperSat on its face on a soft padded flat object, such as a table with a towel or blanket,
taking care not to damage the speaker or grille.
2.
Align Center Channel Foot with matching insert as shown.
3.
Insert the screws through the stand and into the inserts on the speaker's back.
4.
On SuperSat 3C (ONLY), place the plastic washer on the screw after the screw has been inserted through
the stand and before the screw is inserted into the insert in the back of the speaker. The plastic washer
should be between the stand and the back of the speaker if this step has been done correctly
(see illustration).
5.
Tighten the screw into the insert in the back of the SuperSat, do not over tighten.
6.
On SuperSat 50C (ONLY), repeat steps 2, 3 and 5 with the second Adjustable foot.
7.
Adjust the height of the rubber glide in the bottom of the Foot/Feet to achieve the desire angle.
6
►
GoldenEar Technology
#2 Phillips Screwdriver
One Adjustable Foot
One Phillips head screw
One plastic washer
Two Phillips head screws
SuperSat Series Manual
Advertisement
Table of Contents
