Table of Contents
Advertisement
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Push Button on/off
Your Siemens hearing instruments may be programmed to
allow you to turn them on and off using the program button.
To turn the instrument off using the program button, press
and hold the button for 3–5 seconds. To turn it back on, press
and hold the program button for 3–5 seconds. Please note
that after having turned the hearing instrument off using the
program button, you must wait approximately 10 seconds for
the system to reset before turning it back on again by using
the program button.
26
OPERATING YOUR HEARING INSTRUMENT-
PROGRAMMABLE FEATURES
Power on delay
Your hearing instruments may be equipped with an
advanced power on delay feature. This feature delays sound
from entering your hearing instruments when they are first
turned on so that you may insert the instruments into your
ears without experiencing unpleasant feedback (whistling).
Low battery indicator
Your hearing instrument may be programmed to inform you
when the battery should be replaced for best performance.
You may hear an intermittent series of beeps and/or
experience low amplification power or volume. Change
the battery immediately if either of these should occur.
Volume control alert tones
Your hearing instrument may be programmed to inform you
of changes to volume. You may hear soft beeps each time
you change the volume and a three beep warning when
the volume limit has been reached. Once the maximum or
minimum volume has been reached, further changes in that
direction will have no effect.
Program change alert tones
Your hearing instrument may be programmed to inform
you of changes to the program. The program change may
be confirmed by alert tones or beeps that correlate to the
program you are in. That means if you select Program 3, the
hearing instrument will beep 3 times.
OPERATING YOUR HEARING INSTRUMENT-
27
OPTIONAL FEATURES
Hide quick links:
Advertisement
Table of Contents
