Advertisement
3.
Holders and holder assembly
I
(optional accessories)
The holders and the holder assembly
can be installed on either side as a con-
venient means of supporting work-
pieces horizontally. Install them as
shown in the figure. Then tighten the
screws firmly to secure the holders and
the holder assembly.
When cutting long workpieces, use the
holder-rod assembly (optional acces-
sory). It consists of two holder assem-
blies and two rods 12.
Screw
Holder assembl
Screw
Holder assembly
1
Rod 12
CAUTION:
Always support long workpieces level with the top surface of
the
turn base for accurate
cuts and to prevent dangerous loss of control of the tool.
Operation
CAUTl ON:
*Before use, be sure to release the handle from the lowered position by pulling the stop-
per pin.
*Make sure the blade is not contacting the workpiece, etc. before the switch is turned on.
*Do not apply excessive pressure on the handle when cutting. Too much force may result
in overload of the motor and/or decreased cutting efficiency.
*Gently press down the handle to perform the cut. If the handle is pressed down with
force or if lateral force is applied, the blade will vibrate and leave a mark (saw mark) in the
workpiece and the precision of the cut will be impaired.
12
Advertisement
