Advertisement
When cutting with this tool, the thickness
of the blade is cut out of the workpiece as
well. Therefore, your cutting line should be
on either the left or right side of the groove
in the kerf board. Switch on the tool and
wait until the blade attains full speed before
lowering gently into the cut. When the
blade, contacts the workpiece, gradually
bear down on the handle to perform the
cut. When the cut is completed, switch off
the tool and WAIT UNTIL THE BLADE HAS
COME TO A COMPLETE STOP before
returning the blade to its fully elevated posi-
tion
.
A thin piece of cut off material could
CAUTION:
When cutting long workpieces, use sup-
ports that are as high as the top surface
level of the turn base.
Cutting line
G ~ M ?
1. Cutting crown and cove moldings
*Crown and cove molding can be cut on a compound cut with the moldings laid flat on
the turn base.
*There are two common types of crown moldings and one type of cove molding;
52/38"
wall angle crown molding, 45" wall angle crown molding and 45" wall angle cove mold-
ing. See illustrations below.
Ceiling
Ceiling
Ceiling
-
-
-
-
2
3
45" type
cove molding
13
Advertisement
