Casio PF-8000 Operation Manual page 26

For example, when n = 4, this means that the display will change once in about 0.55
seconds.
(Touch mode)
OHIO lights up.
In cases where "n" has been omitted or where "0" or a letter of the alphabet has been
input, the display occurs at the same speed as when n =6. If "n" occupies more than two
places, the speed will be determined by the first digit of that number only, (n = 1 and
n = 123 will produce the same display speed.)
'While the AUTO DISP •*• ( 4 ) command is in operation, the display can be stopped
temporarily by pressing theSkey. Operation can be continued by simply pressing
the [Silkey once more.
49
(3) FINGER SPEED command
• In the finger mode, designates the finger input speed.
There are 9 levels for finger input speed.
* By inputting n (n = 1 through 9) prior to press|m|key, the finger input speed can
be changed. The following table lists the finger input speeds. (Speed time is approxi-
mate.)
n
Speed (sec)
1
0.29
2
0.35
3
0.42
4
0.48
5
0.55
6
0.61
7
0.67
8
0.74
9
0.80
For example, when n = 8 this means that the speed will change once in about 0.74 sec-
onds. After All Reset button is pressed, the speed is designated at n = 5 automatically.
. ,
«Sa)B-B FINGER SPEED
(Touch mode)
m
In cases where "n" has been omitted or where "0" or a letter of the alphabet has been
input, the previous set speed will not change.
If "n" occupies more than two places, the speed will be determined by the first digit of
that number only, (n = 1 and n = 123 will produce the same speed.)
50