Radial Engineering Ltd. will not be held liable for any consequential or inconsequential costs or damages associated with the use of the SW8. It is understood that connecting, testing and operating the SW8, along with the application or misapplication, is the sole responsibility of the end user.
You simply designate the fi rst SW8 as a master unit and link as many slaves as you like using the JR2 link jacks. The Radial SW8 has gained international notoriety as is used on stage every day with artists as diverse as U2, Lady Gaga, The Eagles, Radiohead and Cirque Du Soleil. Radial Engineering Ltd. ™ MK2 User Guide...
19. JR2-IN and LINK-OUT: ¼” TRS input may be used with the JR2 instead of the XLR. Also used to link multiple SW8’s together for larger 16 and 24 channel playback systems. Radial Engineering Ltd. MK2 User Guide ™...
PIN-1 PIN-1 PIN-1 PIN-1 PIN-1 PIN-1 GLOBAL TONE SOUND REINFORCEMENT SYSTEM PRIMARY-A MULTI-TRACK PLAYBACK SYSTEM BACKUP-B CONTROL MULTI-TRACK Front XLR outputs connect to PA system. Rear D-Sub output connected to local monitoring station. Radial Engineering Ltd. ™ MK2 User Guide...
To use the mute function, depress the MUTE switch on the front panel. An LED indicator illuminates when the function is active to alert you the XLR outputs are muted. Depress the MUTE switch again to turn the function off and restore playback through the XLR outputs. Radial Engineering Ltd. MK2 User Guide ™...
GATE input falls below the set THRESHOLD level, the relay closes allowing current to fl ow through the external alarm circuit and the front panel ALARM LED illuminates. When the drone track is restored the relay opens and the alarm turns off. Radial Engineering Ltd. ™...
JR2 footswitch. The standby control mode switch on the top cover allows Use the STANDBY CONTROL MODE switch you to choose LOCAL control via the front panel switch or REMOTE control. to choose between local or remote control. Radial Engineering Ltd. MK2 User Guide ™...
When combining two SW8 MK2 (second generation) units together, make sure the LINK-MODE switch on the top panel is set to the SW8 MK2 position. When combining your second generation SW8 MK2 with a fi rst generation SW8 MK1, the switch needs to be set to the SW8 MK1 position.
‘lifted’ allowing the chassis to ‘fl oat’ ungrounded. Should a specifi c grounding scheme require the cable shields to be bonded to the chassis, remove the top cover and set the eight switches to the closed (pushed in) position. The switch may be accessed by removing the top cover. CHASSIS GROUND 8 CHASSIS GROUND 1-7 Radial Engineering Ltd. MK2 User Guide ™...
RADIAL ENGINEERING LTD. 3 YEAR TRANSFERABLE LIMITED WARRANTY RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in material and workmanship and will remedy any such defects free of charge according to the terms of this warranty. Radial will repair or replace (at its option) any defective component(s) of this product (excluding fi...