Freezer Compartment - GE ZIB240P Technical Service Manual

Freezer Compartment

To remove the freezer compartment:
1. Remove ice storage bin, drawer, and shelves.
2. Remove the freezer thermistor cover. Unclip
the freezer thermistor from the holding
bracket.
3. Remove the control panel.
4. Remove the 3 Phillips-head screws from the
top-front of the freezer compartment.
5. Remove the 4 Phillips-head screws from the
rear of the freezer compartment.
6. Pull the freezer compartment forward
approximately 2 to 3 inches inches to access
the icemaker plug and groundwire.
7. Disconnect the icemaker plug. Disconnect the
ground wire at the fi ll tube heater.
8. Pull the freezer compartment forward as
shown until clear.
9. Reverse the procedure to install.
Caution:
• Make sure the 6-pin connector is pushed
down and out of the way when sliding
the freezer compartment back into place.
Damage to the 6-pin connector can result.
• Make sure the freezer thermistor does not get
pinched when sliding the freezer compartment
back into place.
6-Pin Connector
– 12 –
Thermistor