Operating Instructions - Girard Products GSWH-1 Owner's Manual

Figure 6
Insert exhaust tube
through door opening
This completes the installation of the Model GSWH-1 water heater.
• Use with LP gas only.
• Shut off gas appliances and pilot lights when refueling.
• Turn gas OFF at the LP tank when vehicle is in motion. This disables all gas
appliances and pilot lights. Gas appliances must never be operated while
vehicle is in motion.
• LP tanks must be filled by a qualified gas supplier only.
• Should overheating occur, turn gas OFF at the LP tank and turn the operating
switch to the OFF position.
• DO NOT TURN ON THE COLD WATER FAUCET TO ADJUST THE
TEMPERATURE.

OPERATING INSTRUCTIONS

CONSUMER SAFETY WARNING
WARNING! CAUTION!
• Disconnect the unit from the gas supply
line during any pressure testing of the
gas system in excess of ½ PSIG
(3.4 kPa, 14" water column [W.C.]). DO
NOT set inlet pressure higher than the
maximum indicated on rating plate of gas
valve (13" W.C.).
• If an external electrical source is utilized,
the appliance, when installed, must be
electrically grounded in accordance with
local codes or, in the absence of local
codes, with the National Electrical Code,
ANSI/NFPA 70 and/or the CSA C22.1,
Canadian Electrical Code.
P a g e 10