Pre-Assembly - Breckwell SW940 Owner's Operation And Instruction Manual

UNPACK AND INSPECT
Remove the packing from the appliance and inspect for any damage. Your appliance is packed with the door handle in a non-
operational position for shipping purposes. The correct operating position is with the handle rod pointed towards the fl oor, at an
approximate angle as illustrated below. Ensure that the bricks are positioned correctly and not broken (see illustration for proper brick
arrangement). Make sure that the baffl e board, above the air tubes, is in place and undamaged. DO NOT remove the baffl e board.
Brick Confi guration
TOOLS AND MATERIALS NEEDED FOR INSTALLATION
You must choose one of the three offered kits:
A) Pedestal Kit (SA940P)
B) Leg Kit (SA940L)
C) Fireplace Insert (SA940i)
Refer to the instructions found inside each kit for proper assembly.
A 7/16" socket wrench
A 5/16" socket (Best if using a power drill and a socket bit)
A pair of pliers or channel-locks
A power drill with an 1/8" drill bit to install sheet metal screws into connector pipe.
Sheet metal screws
A non-combustible fl oor protector as specifi ed in this manual
All chimney and chimney connector components required for your particular venting installation.
Breckwell

PRE-ASSEMBLY

Door Handle Proper Operational Position
3