Optoma HD86 Service Manual page 70

Delta Elec. Inc.
Company Confidential
70
HD86
Lamp Replacing Procedure:
1.
2.
3.
4.
5.
6.
7.
To replace the lamp module,
reverse the previous steps.
1.
after the lamp module is replaced.
Lamp Reset:
(i)Press "Menu" -> (ii)Select "System" ->
(iii)Select "Lamp Settings" ->
(iv)Select "Lamp Reset" ->
(v)Select "Yes".
Optoma___________________
Switch off the power to the projector by
pressing the Power button.
Allow the projector to cool down at least 30
minutes.(1)
Disconnect the power cord.
Unlock the lamp cover. (2)
Pull up and remove the cover. (3)
Use a screwdriver to remove the screws
from the lamp module. (4)
Pull out the lamp module. (5)
Turn on the projector and do "Lamp Reset"
Delta________________
2009/08/18