Pioneer HTZ180DVD Operating Instructions Manual page 9

Connecting up
2 Connect the AM and FM antennas.
a. Pull off the protective shields of both AM
antenna wires. Connect one wire of the AM
loop antenna to each AM antenna
2
terminal.
For each terminal, press down on the tab to
open; insert the wire, then release to
secure.
3
2
b. Push the FM antenna
pin of the FM antenna socket.
3-1 Connect each speaker.
• Connect the wires to the speaker.
• Twist and pull off the protective shields on
each wire.
Note
1 • Keep antenna cables away from the receiver and other cables.
• If reception with the supplied antenna is poor, see Improving poor FM reception on page 18 or Connecting external
antennas on page 40.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 40.
2 • Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical
appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of
the unit.
1
1
3
plug onto the center
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
• Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the
other wire into the black (–) side.
Black (–) Red (+)
When you select the 3 spot speaker layout,
follow steps a through c below to set up the
speakers.
a. The base of each surround speaker fits
into the circular groove on the top of the
front speakers as shown.
Color-coded wire
02
9
En