Start-Up And Use - Hotpoint SH103PX S Operating Instructions Manual

Start-up and use

GB
!
with its door closed at its maximum temperature for at least
half an hour. Make sure that the room is well ventilated
before switching the oven off and opening the oven door.
The appliance may emit a slightly unpleasant odour caused
by protective substances used during the manufacturing
process burning away.
! To make the setting process easier, press and hold the
buttons to scroll through the numbers on the display rapidly.
! Each setting will automatically be stored in the appliance
memory after 10 seconds.
! The touch controls cannot be activated if the user is
wearing gloves.
Control panel lock
! The control panel can be locked while the oven is off, once
To lock the oven controls, press and hold the
for at least 2 seconds. A buzzer will sound and the
TEMPERATURE display shows the key symbol "O—n". The
icon will light up to indicate lock activation.
To deactivate the lock, press and hold the
for at least 2 seconds.
Setting the clock
! The clock can only be set when the oven is switched off. If
the oven is in standby mode, pressing the
display the current time setting. Press it again to set the time.
After connection to the power supply network or after
a blackout, the button and the digits on the TIME display
To set the clock:
1. Press the button.
3. Once you have reached the correct hour value, press
the button.
4. Repeat the above process to set the minutes.
If a blackout occurs, it will be necessary to reset the clock.
If the
clock has not been set correctly.
Setting the minute minder
! The minute minder may be set regardless of whether the
oven is switched on or off. It does not switch the oven on or off.
When the set time has elapsed, the timer emits a buzzer
that will automatically stop after 30 seconds or when any
active button on the control panel is pressed.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
6
! When inserting the shelf
make sure the backstop is
at the rear of the cavity (see
image).
and
button
button again
button once will
and buttons.
1. Press button .
2. Set the desired time using buttons
3. Once you have reached the desired value, press the
button again.
The lit symbol will remind you that the minute minder is on.
To cancel the minute minder, press the
the and buttons to set the time to 00:00. Press button
again.
The icon will switch off to indicate that the minute minder
has been disabled.
Starting the oven
1. Switch the control panel on by pressing the
The appliance buzzer sounds three times (ascending) and
all buttons light up in sequence.
2. Press the button corresponding to the desired cooking
mode. The TEMPERATURE display shows:
- the temperature associated with the mode, if programming
- "Auto", if programming is automatic.
The TIME display shows:
- the duration, if programming is automatic.
3. Press the button to begin cooking.
4. The oven will begin its preheating phase, the preheating
indicators will light up as the temperature rises.
and all the preheating indicator lights show that this stage has
been completed: the food can then be placed in the oven.
6. During cooking it is always possible to:
- change the temperature by pressing the
followed by the and
- press the button to stop cooking. In this case the
- switch off the oven by pressing the
7. If a blackout occurs while the oven is already in operation,
an automatic system within the appliance will reactivate the
cooking mode from the point at which it was interrupted,
provided that the temperature has not dropped below a
certain level. Programmed cooking modes which have not
yet started will not be restored and must be reprogrammed
(for example: a cooking mode has been programmed to
start at 20:30. At 19:30 a blackout occurs. When the power
supply is restored, the mode will have to be reprogrammed).
! There is no preheating stage for the GRILL mode.
!
will prevent the enamel coating from being damaged.
! Always place cookware on the rack(s) provided.
and .
button and use
button.
button,
button for 3 seconds.