Table of Contents
Advertisement
Start-up and use
GB
!
closed at its maximum temperature for at least half an hour. Make sure that
the room is well ventilated before switching the oven off and opening the
oven door. The appliance may emit a slightly unpleasant odour caused by
protective substances used during the manufacturing process burning away.
! To make the setting process easier, keep the knob in position: this will
increase the scrolling speed of the numbers on the display.
! Each setting will automatically be stored in the appliance memory after 10
seconds.
! During operation, we recommend the removal of any crockery or delicate
foodstuffs from the cavities not being used.
! Once cooking has begun, before the DIVIDER is removed, the oven must
be switched off using the
! Every time the oven is switched on it is set to the CREATION cooking mode.
! The touch controls cannot be activated if the user is wearing gloves.
! In order to optimise the cooking performance, when starting the selected
function, product settings will be applied that could cause a delayed start of
the fan and heating elements.
! The oven will begin its preheating phase after 2 seconds from selecting
the desired cycle.
Control panel lock
! The control panel can be locked while the oven is off, once cooking has
To lock the oven controls, press and hold the
seconds. A buzzer sounds and the display shows the key symbol "n—O". The
and
icons, when lit, indicate lock function activation.
To deactivate the lock, press and hold the
seconds.
! When cleaning the appliance, the door lock may be closed accidentally
(there is an exposed spring). If this happens, reopen it by turning the door
KO
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
8
WARNING! The oven is provided
with a stop system to extract the racks
and prevent them from coming out of
the oven (1).As shown in the drawing,
to extract them completely, simply lift
the racks, holding them on the front
part, and pull (2).
button.
button for at least 2
button again for at least 2
OK
Setting the clock
! The clock can only be set when the oven is switched off. If the oven is in
standby mode, pressing the
button once will display the current time
setting. Press it again to set the time.
After connection to the power supply network or after
a blackout, the
10 seconds.
To set the clock:
1. Press the
button.
2. Turn the TIMER knob towards
3. Once you have reached the correct hour value, press the
4. Repeat the above process to set the minutes.
If a blackout occurs, it will be necessary to reset the clock. If the
Setting the minute minder
! The minute minder may be set regardless of whether the oven is switched
on or off. It does not switch the oven on or off.
When the set time has elapsed, the timer emits a buzzer that will automatically
stop after 30 seconds or when any active button on the control panel is
pressed.
To adjust the timer proceed as follows:
1. Press button
.
2. Turn the TIMER knob towards
3. Once you have reached the desired value, press the
The lit
symbol will remind you that the minute minder is on. The DISPLAY
will show the countdown.
To cancel the minute minder, press the
the time to 00:00. Press button
The
icon will switch off to indicate that the minute minder has been
disabled.
Cooling ventilation
In order to cool down the external temperature of the oven, a cooling fan
blows a stream of air between the control panel and the oven door, as well
as towards the bottom of the oven door.In the FAST COOKING mode, the
fan is activated automatically after ten minutes. At the beginning of the FAST
CLEAN mode, the cooling fan operates at low speed.
! Once the cooking has been completed, the cooling fan remains on until the
Oven light
The light comes on when the oven door is opened or when a cooking mode
starts. The
button can be used to switch on the light at any time.
Residual heat indicators
"residual heat" light on the display comes on to indicate high temperatures
inside the oven cavity. The indicator light switches off when the inside of the
oven has cooled down.
and
to adjust the hour value.
button.
and
to adjust the hour value.
button again.
button and use the knob to set
again.
icon
Advertisement
Table of Contents
