Epson Stylus C50 Service Manual page 132

EPSON Stylus C50/C60/C61/C62
When removing the PF roller, be careful not to damage the Spur
C H E C K
gear 60 with the Main frame.
P O I N T
When assembling the PF roller unit to the Main frame,
Be careful not to damage the Spur gear 60 with the Main
frame.
Make sure to set the PF roller bushing to the cutout portion
of the Main frame.
When assembling the Paper guide upper/left to the Main frame,
Avoid to damage the coated surface of the PF roller by using
the OHP sheet. (Refer to Figure 4-69)
Make sure that the Paper guide is correctly fixed to the Main
frame.
[Reference: Procedure for assembling the Paper guide]
1. Set the Torsion spring 48.51 into the groove of the Paper guide
upper/left as shown figure below.
Figure 4-72. Paper guide assembling (1)
Disassembly and Assembly
Torsion spring 48.51
2. Install the Paper guide upper/left to the Main frame as shown
figure below, and slide it to the right side.
Set these protrusions on the Main frame
3. Release the Torsion spring 48.51 by using the tweezers as shown
figure below.
Disassembly
Step2) Slide it to the right side
Step1) Install the Paper guide upper/left
Figure 4-73. Paper guide assembling (2)
Figure 4-74. Paper guide assembling (3)
Revision C
124