Epson Stylus C62 Start Here

EPSON Stylus C62
®
Start
Start
Here
Here
1
1
Unpack
Unpack
1
Remove everything from the box.
Paper
support
Printer
Power cord
2
Remove the tape and
packing material.
3
Peel off the tape beneath the cover
and remove the insert.
4
Slide the paper support into
its three slots on the back
of the printer.
2
2
Connect the Printer
Connect the Printer
Printer connection cables are not included with your printer.
You need only one of the following cables:
• USB cable (PC or Mac) or
• Parallel cable (PC only).
USB Cable Users
1
Shut down your computer. In Windows
or Turn Off option.
2
Plug the flat end of the USB cable into any available USB port on your computer.
3
Plug the square end of the cable into your printer's USB port.
Parallel Cable Users
1
Shut down your computer. Click Start and select the Shut Down or Turn Off option.
CPD-14476
2
4031970-00 Plug the end of the cable with the screws on the side into your computer's parallel port
and secure it.
Ink cartridges
3
Plug the end of the cable with the slotted connector into your printer's parallel port,
then secure it with the wire clips.
Printer Software
CD-ROM
Printer Basics
3
3
Turn On the Printer
Turn On the Printer
1
Plug the printer's power cord into a grounded electrical outlet. (Don't turn on
your computer yet.)
2
Press the
, click Start and select the Shut Down
®
power button to turn it on.
4
4
Install Ink Cartridges
Install Ink Cartridges
1
Open the output tray.
Printer cover
2
Open the printer cover.
3
Lift up both ink cartridge clamps.
4
Unpack the ink cartridges that came
with your printer and remove the
yellow tape from the top.
5
Lower each cartridge down into the holder.
Make sure the tabs rest on the hooks
in the back.
6
Shut the clamps and make sure they
click into place.
7
Close the printer cover.
8
Press the Ink Cartridge Replacement button.
The green power light flashes as your printer
charges ink for about 1 1 / minutes.
2
CAUTION: Don't turn off the printer or
interrupt charging while the power light
is flashing or you'll waste ink.
5
5
Load Paper
Load Paper
1
Load some paper behind the tabs inside the edge guides.
2
Press in the locking tab on the
left edge guide and slide it to fit
lightly against the paper stack.
3
Pull out the output tray extension.
Turn over
Output tray