Window Logon Via Fingerprint Authentication - Toshiba Libretto U100 User Manual

We recommend first-timers to click Practice, and then swipe the finger as a
practice.
5. The Capture Fingerprint screen is displayed. Follow the onscreen
instructions and use the same finger you have selected under Choose
Finger to swipe three times to allow the sensor to read the fingerprint.
The fingerprint will be shown in green if properly read, or in red if the
reading is abnormal.
6. The Verify Fingerprint screen is displayed. Swipe the finger again to
allow the sensor to read again. When the Verification Successful
message is displayed, click Next.
In case of finger injury or authentication failure, it is recommended that
another fingerprint also be enrolled. The following message will be
displayed:
"It is recommended that you enroll at least two fingers. Would you like
to enroll an additional finger now?"
Click Yes and repeat steps 3, 4, 5 and 6 with another finger.
7. The Audio and Taskbar Settings screen is displayed. Click Next.
The Congratulations screen is displayed. Click Done.
8. Click Yes when the following message appears:
"OmniPass has successfully created the new user. Would you like
OmniPass to log on the new user? Once logged on, passwords can be
remembered for the new user."
This completes the fingerprint registration process.

Window Logon via Fingerprint Authentication

In place of the usual Windows logon by ID and password, fingerprint
authentication also allows logon to Windows.
This is useful especially when many users are using the PCs, as user
selection can be skipped.
Fingerprint Authentication Procedure
1. Start up the computer.
2. The Logon Authorization screen is displayed. Choose any of the
enrolled fingers and swipe the fingerprint on the sensor.
If authentication is successful, the user will be logged on to Windows.
If the fingerprint authentication fails, please logon using the Windows logon
password.
Please logon using the Windows logon password if the fingerprint
authentication failed for three consecutive tries. To logon using the
Windows logon password, enter the Windows logon password in the
"Welcome" screen and click on (icon).
A warning message will be displayed when authentication is abnormal or
authentication is not successful within a fixed duration.
User's Manual
Operating Basics
4-7