Samsung NE595N0PBSR User Manual page 65

PROBLEM.
The oven door will
not open after a
self-cleaning cycle.
Oven not clean
after a self-cleaning
cycle.
Steam from the
vent.
Burning or oily odor
emitting from the
vent.
Strong odor.
Fan noise.
Oven racks are
difficult to slide.
Display goes blank.
Display flashes.
Drawer does not
slide smoothly or
drags.
Excessive
condensation in the
drawer.
(Better)NE595N0PBSR_AC_DG68-00428A-02_EN.indd 64
POSSIBLE CAUSE
The oven is too hot.
The oven controls were not set
correctly.
The oven was heavily soiled.
When using the convection
feature, it is normal to see steam
coming out of the oven vent.
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
This is normal in a new oven and
will disappear in time.
An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used.
A convection fan may automatically
turn on and off.
The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.
A fuse in your home may be blown
or the circuit breaker tripped.
There was a power failure.
The drawer is out of alignment.
The drawer is over-loaded or the
load is unbalanced.
There is liquid present in the
drawer.
Uncovered foods.
The temperature is set too high.
SOLUTION
• Allow the oven to cool.
• See the section on self-cleaning on page
51.
• Wipe up heavy spillovers before starting
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
• This is normal.
• To speed the process, set a self-cleaning
cycle for a minimum of 3 hours.
• See the section on self-cleaning on page
51.
• This is temporary.
• This is normal.
• Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven racks with the paper towel.
• Replace the fuse or reset the circuit
breaker.
• Reset the clock.
• Fully extend the drawer and push it all the
way in. See the page 59.
• Reduce weight. Redistribute drawer
contents.
• Remove the liquid.
• Cover food with a lid.
• Adjust the temperature to a lower setting.
troubleshooting _64
31/10/2012 19:43:35