GE WCVH4800K Technical Service Manual page 30

7. Position the gasket behind the front panel door
opening. Close the door.
8. Remove the 2 Phillips-head/10-mm hex-head
screws that attach the top of the front panel to
the cabinet.
9. Lift up, then remove the front panel from the 3
hooks at the bottom of the cabinet.
Line Filter
The line fi lter helps to smooth out any fl uctuations in
voltage, protecting the control board and providing
more reliable operation. The line fi lter is installed
inside the cabinet and is attached to the right side
cabinet brace.
To check the line fi lter, look for the outer surface
to be burnt by heat or a power surge. The fi lter
resistance should be approximately 0 Ω between
the black wire terminals and 0 Ω between the white
wire terminals.
To remove the line fi lter:
1. Remove the top panel. (See
2. Remove the 1/2-in. hex nut that attaches the
line fi lter to the right side cabinet brace.
Note: A lockwasher is located on top of the fi lter.
3. Lower the line fi lter from the brace and remove
the lockwasher.
4. Disconnect the input and output wire harness.
Note: Install both wire harnesses with the triangular
indicator facing outward from the fi lter.
– 30 –
.)
Top Cover
Line Filter