3 Service Navigation
3.1.
Introduction
This service manual contains technical information, which allow service personnel's to understand and service this model.
Please place orders using the parts list and not the drawing reference numbers.
If the circuit is changed or modified, the information will be followed by service manual to be controlled with original service manual.
3.2.
Important Notice
3.2.1.
CCD UNIT:
• The image sensor (CCD) unit which are connected to the lens unit with 3 screws. These screws are adjusted for the Optical tilt.
During servicing, if one of CCD fixing screws are loosened, the Optical tilt adjustment must be performed.
About the Optical tilt adjustment, refer to the "9.3.2 Adjustment Specifications" for details.
3.2.2.
LENS UNIT:
1. The minimum replacement part size of the Lens part is as shown below.
When servicing, replace the following numbered replacement part size as the smallest size.
3.2.3.
About Flexible Cable and Connector
Do not touch carelessly so that the foreign body should not adhere to the terminal part of flexible cable and connector.
Wipe off with a clean cloth and the cotton bud, etc. when the terminal part is dirty.
7