8.3.9.
Removal of the Main P.C.B.
8.3.10. Removal of the Battery Door Unit
NOTE: (When Installing)
Make sure to confirm the following points when installing:
• The Screw is tightened enough.
• Installing conditions are fine. (No distortion, no abnormal-
space.)
• No dust and/or dirt on Lens surfaces.
• LCD image is fine. (No dust and dirt on it, and no gradient
images.)
(Fig. D11)
(Fig. D12)
8.4.
Removal of the CCD Unit
When remove the CCD unit once (the screw(G) is loosened
even a little), the optical tilt adjustment is required.
When loosen the screw(G), necessary the optical tilt adjust-
ment at the end of assembling. (Refer to item "9.3.2.")
To prevent the CCD unit from catching the dust and dirt, do not
remove the CCD unit except for replacing.
28
(Fig. D13)