Charging Your Remote; Setting The Backlight Timing - Logitech Harmony 700 Quick Start Manual

Charging your remote

Your Harmony 700 comes with an AC adaptor for charging the batteries in
your remote. To charge the batteries, just insert the USB cable into the top
of the remote, plug the other end of the cable into the AC adaptor, and then
plug the AC adaptor into a wall outlet and charge.

Setting the backlight timing

The Harmony 700 senses when you pick it up, and lights up the display and buttons.
To set the length of time the backlight stays on, follow these steps:
From your Harmony Remote Software:
1.
2.
3.
10
Use only NiMH replacement batteries, size AA R6 with
a minimum of 1800 mA.
Caution: Risk of explosion if battery is replaced by an
incorrect type. Use and replace only with same type and
rating as the battery provided. Charge only with
the power outlet adapter provided with your remote.
Select the Remote Settings tab.
Click
Display Settings.
Next to Glow Timing, select the number of seconds before the backlight turns off
automatically, and click Save.