Opening The Door After The Programme Has Started; At The End Of The Programme - AEG Electrolux LAVAMAT 84950 Instruction Booklet

22 Use

Opening the door after the programme has started

First set the machine to pause by pressing the START/PAUSE button.
If the messages «Pause» and «Door unlocked» appear alternately on the
●
display, the door can be opened.
the messages «Pause» and «Door unlocked» don't appear on the display,
If
●
this means that the machine is already heating, that the water level is above
the bottom edge of the door or that the drum is turning. In this case the
door can not be opened.
If you cannot open the door but you need to open it you have to switch the
●
machine off by turning the selector dial to «O/OFF». After about some
minutes the door can be opened (pay attention to the water level and
temperature!).

At the end of the programme

The machine stops automatically.
The START/PAUSE button pilot light goes off, flashing «
display and the acoustic signal sounds for some minutes.
If the Rinse Hold
Start/Pause pilot light goes off, the messages «Door locked» and «Rinse hold»
appear on the display, the door is blocked to indicate that the water must be
emptied out.
To empty out the water please read the steps on the «Rinse hold» option
paragraph.
Turn the programme selector dial to «O/OFF» to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
or Night Cycle
0.00
option has been selected, the
» appear on the