Table of Contents
Advertisement
the previous washing programme. Start the new programme by pressing the button 7 again.
The washing water in the tub will be not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme which is running, the corresponding light
starts blinking. Press the same button again to restart the programme.
Cancelling a programme
Turn the selector dial to
Press the button 5 to cancel the programme which is running.
Now press the button 7 to start the new programme.
Opening the door after the programme has started
First set the machine to Pause by pressing the button 7 .
• If the display says that the appliance is in pause, the door can be opened
• If the display says alternately that the appliance is in pause and the door is locked, this
means that the machine is already heating, that the water level is above the bottom
edge of the door or that the drum is turning: in this case the door can not be opened
• If you cannot open the door but you need to open it you have to switch the machine
off by turning the selector dial to
(pay attention to the water level and temperature!) .
After closing the door, it is necessary to select the previous programme again and to press
the button 7 , the machine will resume the programme from the point where it had been
interrupted.
At the end of the programme
The machine stops automatically. The pilot light of the button 7 goes off, a static
appears on the display and the acoustic signal sounds for some minutes.
If the RINSE HOLD or NIGHT CYCLE option has been selected, the pilot light of the button
7 goes off, the display says that the door is locked and the RINSE HOLD option has been
selected, the door is blocked to indicate that the water must be emptied out.
Please follow the below instructions to empty out the water:
• turn the programme selector dial to
• select the DRAINING or SPINNING programme and confirm it by pressing button 5 ,
• reduce the spin speed if needed, by means of the relevant button,
• press the button 7 ,
• when the programme has finished the display shows a static
that the programme is finished. The door can be opened.
Turn the programme selector dial to
from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open
to prevent the formation of mildew and unpleasant smells.
and then in the new selected programme.
. After about some minutes the door can be opened
/OFF,
/OFF to switch the machine off. Remove the laundry
17
Daily use
and the display says
Hide quick links:
Advertisement
Table of Contents
