Advertisement
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOW-
1.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards(ANSI/
NFPA 70-1996), including fire-rated construction.
2.
Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer.
3.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and ungrounded conductor on the other side of the outlet box.
4.
Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
5.
Be cautious! read all instructions and safety information before installing your new fan. Review the accompanying assembly diagrams.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
6.
Make sure the installation site you choose allows the fan blades to rotate without any obstructions. Allow a minimum clearance of 7
7.
feet from the floor to the trailing edge of the blade.
To reduce the risk of fire, electric shock, or personal injury, mount to outlet box or supporting system acceptable for fan support.
8.
(Mounting must support at least 35 lbs.)
9.
Do not bend blade holders during installation to motor, balancing or during cleaning. Do not insert foreign object between rotating
blades.
10.
Attach the mounting bracket using only the hardware supplied with the outlet box.
11.
To reduce the risk of fire or electric shock, do not use this fan with any solid state fan speed control device, or variable speed control.
12.
If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application.
13.
NEVER place a switch where it can be reached from a tub or shower.
14.
The combustion airflow needed for safe operation of fuel-burning equipment may be affected by this unit's operation. Follow the
heating equipment manufacturer's guideline safety standards such as those published by the National Fire Protection Association
(NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
15.
Before servicing or cleaning unit, Switch power off at Service panel and lock service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such
as a tag, to the service panel.
Unpack and inspect fan carefully to be
1
certain all contents are included. (See
exploded view parts list.)
Install mounting bracket to outlet box
4
in ceiling using the screws provided
with the outlet box and washers.
I
NSTALLATION
READ AND SAVE THESE INSTRUCTIONS
TOOLS REQUIRED
Phillips Screwdriver
Wire Cutters
2
Turn off power at breaker box to avoid
possible electrical shock.
Feed motor lead wires through downrod/
canopy assembly and insert downrod
into motor yoke. Next, insert clevis pin
through yoke and downrod and secure
with cotter pin. (see inset) Tighten both
5
yoke set screws to further secure
downrod.
Safety Tips
ING:
Pliers
Cotter
Pin
Clevis
Pin
Set
Screws
Step Ladder
Use outlet box suitable for fan support.
Secure outlet box directly to the building
3
structure using ceiling joist screws.
Outlet box must support 35 lbs.
Ridge
Ball Notch
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on
the ball engages the ridge in the
6
mounting bracket. This will allow hands-
free wiring.
Advertisement
