Advertisement
mind your manners
Filling holes and obeying NO TRESPASSING Signs are but 2 require-
ments of a dedicated metal detector hobbyist. A sincere request that
Kellyco makes to every user of a detector is that each place searched be
left in a better condition that it was found. Thousands of individuals and
organizations have adopted this formal.
Metal Detector Operators Code of Ethics:
• I will respect private and public property, all historical and archaeological
sites and will do no metal detecting on these lands without proper permis-
sion.
• I will keep informed on and obey all laws, regulations and rules governing
federal, state and local public lands.
• I will aid law enforcement officials whenever possible.
• I will cause no willful damage to property of any kind, including fences,
signs and buildings and will always fill holes I dig.
• I will not destroy property, buildings or the remains of ghost towns or other
deserted structures.
• I will not leave litter or uncovered items lying around. I will carry all trash
and dug targets with me when I leave each search area.
• I will observe the golden rule, using good outdoor manners and conduct-
ing myself at all times in a manner which will add to the stature and public
image of all people engages in the field of metal detection.
Warning!
Any metal detector may detect underground power lines, explosives or
other items which when struck could cause personal injury. When search-
ing for treasure with your detector, observe these precautions:
Do not hunt in an area where you believe there may be shallowly buried
underground electric lines or pipes.
Do not hunt in a military zone where bombs or other explosives may be
buried.
Avoid striking any line known to be or suspected to be carrying electrical
power.
Do not disturb any pipeline, particularly if it could be carrying flammable
gas or liquid.
Use reasonable caution in digging toward any target, particularly in areas
where you are uncertain of underground conditions.
10
assemBly —
1.
Unpack your metal detector carefully. Slip the lower stem into the
middle stem. Adjust the stem length and coil angle. The stem length is
adjusted by loosening the lower lock nut and allowing the spring clip to
snap into one of the holes in the center stem. The coil angle is adjusted
by loosening the nylon wing nut on top of the search coil. With the stem
length properly adjusted, wrap the coil cable snugly around the lower
stem and the center section. Leave just enough slack near the coil to
allow it to be tilted completely backward and forward.
CONTrOL UNIT
& PANeL
ArM reST
UPPer
STeM
NOTE: A Loose cable near the search coil may cause false signals, but
don't wrap it so tightly that it pulls against the housing or the coil.
2.
Install (2) 9-Volt batteries and then the detector will be ready for
use.
ConTrol Panel —
• FAcTORy REcOMMEND
STARTING POINT
(Pre-Set Position)
PRE SET
5
4
6
3
7
3
2
8
2
1
9
1
0
10
0
SENSITIVITY
DISCRIMINATE
PIN POINT/
BATTerY
TeST LIGHT
PINPOINT
PINPOINT
High Performance – Deep Searching
BUTTON
MIDDLe
SeArCH
LOwer
STeM
COIL
STeM
CABLe
NYLON
UPPer
LOwer
NUT & BOLT
LOCK NUT
LOCK NUT
POwer
PRE SET
ON/OFF
5
4 5
4
6
6
3
7
7
VOLUMe
8
2
8
CONTrOL
9
1
9
10
0
10
ON / OFF
PRE SET
VOLUME
• FAcTORy
REcOMMEND
STARTING
POINT
(Pre-Set
Position)
MP
5
PRO
3
Advertisement
