Panasonic WV-NS954 Installation Manual page 15

• It is recommended to use Panasonic's SD memory
cards (64 MB, 128 MB, 256 MB, 512 MB, 1 GB and
2 GB) since they have tested and confirmed full
compatibility with this product. If another SD mem-
ory card is used, this product may not work proper-
ly or performance deterioration may be caused.
Radio disturbance
When this product is used near a TV/radio antenna, or a
strong electric field or magnetic field (such as near a
motor or a transformer), images may be distorted and
noise may be caused.
Router
When connecting this product to the Internet, use a
broadband router with the port forwarding function
(NAT, IP masquerade).
Refer to the setup instructions (PDF) for how further
information about the port forwarding function.
How to Assemble the Cable with the Accessory
Connector
Strip back the cable jacket approx. 3 mm {0.1"} and
separate the individual conductors.
Approx.
3 mm {0.1"}
A
Up
Insert
Contact
Prepare the individual conductors for clamping. Use
MOLEX band tool part number 57027-5000 (for UL-
Style Cable UL1015) or 57026-5000 (for UL-Style
UL1007) for clamping the contacts.
After clamping the contacts, push them into the proper
holes in the accessory connector of this camera until
they snap in place.
Cautions:
• Shrinking the cable-entry seal is a one-time proce-
dure. Do not shrink the cable-entry seal until ascer-
taining that the unit is functioning.
• CONNECT THIS TO 24 V AC CLASS 2 POWER
SUPPLY ONLY.
Wire
Insert the wire until A position
and clamp the contacts.
Up
Wire
Contact
15