Condenser Fan And Motor; Icemaker; Wheel Assembly - GE GSS20 Series Technical Service Manual

Wheel Assembly

Removal and Replacement
Unplug the refrigerator and lay the refrigerator on
its back side.
Remove 3 screws from the bottom of the wheel
assembly.
Screw
Remove the wheel assembly by guiding the wheel
adjustment screw through the wheel adjustment
screw hole.

Icemaker

The orange and brown wires at the icemaker will
read 120 VAC.
Removal and Replacement
Switch
Screw
Bucket
Turn the icemaker switch to the OFF position.
Remove the icemaker bucket and cover.
Unplug the icemaker connector.
Remove 2 screws, then remove the icemaker.

Condenser Fan and Motor

Note: The condenser fan harness is 3 inches
longer to accommodate maintenance.
Removal and Replacement
Remove 6 screws, then remove the cover from
the rear of the refrigerator.
Adjustment screw
Pull the fan blades off of the end of the fan shaft.
Caution: The grommet in the fan motor bracket
may fall out.
Remove 2 screws from the fan motor bracket,
then remove the fan motor bracket.
Remove the fan motor and disconnect the
electrical connector.
– 9 –
Connector
Grommet
Bracket
Blades
Motor
Screws