Operating Sequence - Electrolux EWS 1050 Instruction Manual

1 2 3 4
1
/
2
/
3
4
5 6 7 8 9 10 11 12
5
/
/
/
8

Operating sequence.

Before washing your first load of laundry we recom-
mend that you run a cotton cycle at 60 with the
machine empty, in order to remove any manufac-
turing residue from the drum and tub.
1. Place the laundry in drum
Open the door.
Place the laundry in drum, one item at a time,shaking
them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment.
If you wish to carry out the prewash, pour detergent
into the appropriate compartment marked.
3. Measure out the additives
If required, pour fabric softener into the compartment
marked, without exceeding the MAX mark.
4. Switch the machine on
To switch the machine on, press the ON/OFF button :
the mains-on light comes on. The display will show
three blinking dashes or a blinking zero.
5. Select the desired programme/
fabric
Press the FABRICS button repeatedly, in order to
select the desired programme/fabric. The relevant light
will light up. The lights relevant to the phases that form
the programme will light up. The display will show the
duration of the selected programme, calculated on the
basis of the maximum load for each type of fabric.
The light of the START/PAUSE button will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the execution of
the cycle.
6. Select temperature
Press the TEMPERATURE button if you wish to select
a temperature value different from the one proposed
by the washing machine. The relevant light will light up.
15