Electrolux EWS 1050 Instruction Manual page 2

Problem
The door can not open :
Spinning starts late or the laundry
is not spun enough :
Water is not
visible in the machine? The machine,
which is the result of modern technology, runs
in a very economical way with low water
consumption. Performance is
nevertheless excellent.
If you are unable to identify or solve the problem,contact our service centre. Before telephoning, make a note
of the model, serial number and purchase date of your machine: the Service Centre will require this information.
Contents of this user manual may be modified without informing you.
Possible cause
The program is still running and the drum is turning.
The door lock has not yet released.
The water level is above the bottom edge of the door.
The machine is heating the water, and the water
temperature is higher than 55
The door can only be opened when the relevant light
has gone out.
The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum.The laundry is redistributed by reverse
rotation of the drum.This may happen several times
before the unbalance disappears and normal spinning
can resume.if ,after few minutes,the laundry is still
not evenly distributed in the drum,the machine will
spin at a lower speed or will not spin.If at the end of
the programme the laundry is not spun enough,
redistriute the load manually and select the spin
programme.
The machine makes an unusual
noise? The machine is fitted with a commutator
motor which improves machine
performance.
22
1