Front Insert Interior Connections - Heatmaster G100 Operation And Maintenance Manual

G Series Outdoor Furnaces
BUILDING CONNECTIONS
BUILDING CONNECTIONS
A hole large enough to accommodate the water lines, insulation and PVC piping through
the wall is important. Attention to sealing this point on both sides is also important.
INTERIOR CONNECTIONS
INTERIOR CONNECTIONS
You may require either a water-to-water (tube and shell or plate) or a water-to-air ex-
changer (rad) to transfer heat energy from the hot water your furnace has produced.
Your plumber or dealer can design and install a system to best fit your needs. The fol-
lowing are examples of basic interior connections. SteelTech Inc. carry the necessary
parts for installation.
It is important to note that when installing your piping system in your building that you
should avoid installation methods that cause too great a restriction in the piping system.
Examples of this are reducing pipe size, an excessive amount of joints and elbows, etc.
This may build up enough pressure to damage your piping, heat exchangers or other
parts of your furnace.
DISCLAIMER: The following information in the interior connections are examples and
DISCLAIMER:
suggestions only. When installing a furnace and its parts it is best to consult your local
dealer or a qualified technician.
- 10 - www.heatmasterss.com