Keyset Mode - Vodavi STARPLUS STS User Manual

Keyset Mode

SINGLE LINE TELEPHONE
To place an intercom call:
1. Lift the handset.
2. Dial the intercom number. You will hear ringing if the called
station is in the "T" answering mode or two bursts of tone if
the called station is in the "H" or "P" modes.
3. Hang up to end the call.
To answer an intercom call:
Lift the handset,
-or-
If your SLT is equipped with a speakerphone, press the
Speaker button to converse in a handsfree mode.
Keyset Mode
This feature allows you to determine the mode and baud rate
of the optional CTI Module connected to your phone. This
setting is stored in back-up memory in the case of a power
outage or system reset. When telephone is set to AT command
mode, these AT commands are supported.
Mode
Inactive No CTI information is sent/received by the telephone.
ATD Modem Dialing Command -- The telephone will recognize the
ATD and accept digits after the command.
ATH or Modem On-Hook/Off-Hook Command -- ATH or ATH0 will
ATHX force the telephone to go to the on-hook state from its current
(X= 0 or 1) state. ATH1 will force the telephone to go to the off-hook state
from it's current state.
CKTU Command used with Wanderer (a cordless key telephone unit).
The baud rate is not used in this mode; no change is necessary.
PC Phone CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI Service Provider Interface -- Command used with TAPI
applications such as Discovery Link
Description
53