Table of Contents
Advertisement
On the back of the radio weather station:
1. Insert button cells (2 x CR 2032 3 V) or connect the optional
power adapter (see Page 13).
Note the polarity shown.
2. Select the temperature unit with the °C/°F button.
3. Specify the unit for the air pressure display with the mb/hPa /
inHg button.
mb/hPa = millibar/hectopascal
inHg = inches of mercury column
4. Push the Reset button with a pointed object.
✓ The radio weather station searches for radio sensors. The search
is ended automatically after 5 minutes.
If during the search a channel in the temperature/humidity range
is switched to, the search is indicated by the flashing of the fol-
lowing symbols:
5. Set time and date format if necessary (see Page 21)
6. Adjust inside temperature display if necessary (see Page 18).
i
Searching for radio sensors
The search for radio sensors can be restarted
(e.g. after changing the batteries), by switching to the temperature/
humidity area with Mode and then pressing and holding Memo
and Ch for 2 seconds.
Assigning several radio weather stations
i
to a radio sensor
Up to five radio weather stations can be assigned to a radio sensor.
For this, the Reset button must be pressed at each radio weather
station during commissioning.
7
Advertisement
Table of Contents
