Installation - Alpine PDR-M65 Owner's Manual

INSTALLATION

Due to the high power output of the PDR-M65/
PDR-F50, considerable heat is produced when the
und to
amplifier is in operation. For this reason, the
ing
amplifier should be mounted in a location which
s in
will allow for free circulation of air, such as inside
pment
the trunk. For alternate installation locations, please
y, and it
contact your authorized Alpine dealer.
ordance
1. Remove the hexagon screws using the supplied
Hexagon Wrench (small). (Fig. 1)
nit in
e is
anty,
2. Slide the Top Cover, and lift it to remove. (Fig. 2)
• Be sure not to damage the indicator area.
which
d States
r dealer
ge.
..............4
......1 SET
..............1
3. Using the amplifier as a template, mark the four
screw locations.
4. Make sure there are no objects behind the
surface that may become damaged during
drilling.
5. Drill the screw holes.
Hexagon Screws
Top Cover
6. Position the PDR-M65/PDR-F50 over the screw
holes, and secure with four self-tapping screws.
(Fig. 3)
Self-Tapping Screws (M4 × 20)
Holes
Fig. 1
Chassis
NOTE:
• To securely connect the ground lead, use an
already installed screw on a metal part of the
vehicle (marked ( )) or a clean, bare metal spot
on the vehicle's chassis. Be sure this is a good
ground by checking continuity to the battery (–)
terminal. Connect all equipment to the same
ground point while keeping wire length as short
as possible. These procedures will help eliminate
noise.
Fig. 2
ALPINE PDR-M65/PDR-F50 68-25285Z55-A (EN/FR/ES)
Holes
Ground Lead
Fig. 3
3
-EN
EN
FR
ES