Auto Disconnect Setup; Auto Answer; Memory Programming; Ringer Set Up - Linkcom Link 904 User Manual

2.5 AUTO DISCONNECT SETUP

The Link 904 can be set to auto-disconnect the line after
either 60 seconds or 120 seconds if the user is silent.
This can be set via switch SW9 located on the base of the
unit. To activate the facility switch SW9 to either '60s' (60
seconds) or '120s' (120 seconds).

2.6 AUTO ANSWER

The link 904 can be set to auto answer a telephone call
after 5 rings. To select this option set switch SW5 to 'ON'.

2.7 MEMORY PROGRAMMING

The one-touch memory buttons can be programmed as
follows:
- Press [SPEAKER ON]
- Press [STORE] (located under memory label)
- Press [M1], [M2], [M3] or [M4]
- Enter the telephone number to store
- Press [STORE]
- Press [SPEAKER ON] to end procedure.

2.8 RINGER SET UP

The ringer volume and ringer melody can be adjusted as
follows:
RINGER VOLUME
LOW - Press [SPEAKER ON][STORE][6][1][STORE]
MED - Press [SPEAKER ON][STORE][6][2][STORE]
HIGH - Press [SPEAKER ON][STORE][6][3][STORE]
RINGER MELODY
MELODY 1 - Press [SPEAKER ON][STORE][7][0][STORE]
MELODY 2 - Press [SPEAKER ON][STORE][7][1][STORE]
MELODY 3 - Press [SPEAKER ON][STORE][7][2][STORE]
MELODY 4 - Press [SPEAKER ON][STORE][7][3][STORE]
MELODY 5 - Press [SPEAKER ON][STORE][7][4][STORE]
RINGER ON/OFF
ON - Press [SPEAKER ON][STORE][9][1][STORE]
OFF - Press [SPEAKER ON][STORE][9][0][STORE]
Link 904 – User Manual
6