Furuno 1833 Installation Manual page 31

Item
IP ADDRESS
HOST NAME
RADAR SOURCE
CHART SOURCE
SOUNDER
SOURCE
SUBNET MASK
GATEWAY
ADDRESS
OFFSET PORT
NUMBER
Model
MODEL1722/1732/1742/1762
MODEL1722C/1732C/1742C/1762C/1752C
MODEL1833/1933/1943
MODEL1833C/1933C/1943C/1953C
GD-1700/1700C
GD-1900C
Contents of Network setup menu
Description
This address is assigned at the factory. Change
the address (last three digits; 001 to 254) when
like models are connected directly or through the
hub. Do this change before connecting the
equipment to the other equipment or hub to
distinguish. Do not set the same IP address in the
network.
Set the name for your display unit to distinguish it
from others in the NavNet system. Confirm that
two equipment don't have same host names. The
host name has been preset depending on the
series of NavNet. See the table in below. This host
name is used for RADAR SOURCE and CHART
SOURCE.
Enter the host name "RADAR (preset)" or the new
name set at HOST NAME item setting if the unit
has been changed of the network radar to use for
the radar display.
Enter a host name (set at HOST NAME) of
network display unit to select equipment which has
chart card in its slot (Max. three units, excluding
own) to use.
The host name of the network sounder ETR-6/10N
is preset (SOUNDER) to use for the video sounder
display. Clear the host name when no network
sounder is connected.
Not used. Reserved for future use.
NavNet equipment default settings
IP ADDRESS
172.031.003.004
172.031.003.001
172.031.003.002
172.031.003.003
172.031.014.001
172.031.003.003
Default Setting
172.031.003.002
RADAR
RADAR
None
SOUNDER
255.255.000.000
000.000.000.000
10000
HOST NAME
RADAR
RADAR
RADAR
RADAR
PLOTTER
PLOTTER
3-3