External Buzzer (Op03-136, Option) Connection - Furuno 1833 Installation Manual

NETWORK port
Other NavNet equipment should be connected to this port with the optional NavNet cable.
Available equipment are shown below.
Radar
MODEL1722/1732/
1742/1762/1722C/
1732C/1742C/1762C/1752C
1833/1933/1943/
1833C/1933C/1943C/1953C
2.2

External Buzzer (OP03-136, option) Connection

The optional external buzzer provides a louder alert when the guard alarm is violated.
External buzzer
Type: OP03-136
Code no.: 000-096-443
Further, you need the optional cable assy MJ-A7SPF0007-050 (w/7P connector, 5 m, code
no. 000-144-418).
1. Attach the MJ-A7SPF0007-050 cable assy (option) to the DATA 3 port at the rear of the
display unit.
2. Cut the XH connector at the end of the external buzzer cable with appropriate length.
3. Solder the cables made at step 2 with MJ-A7SPF0007-050 cable as shown below.
External buzzer
4. Fasten the buzzer with the double-sided tape or two tapping screws (3x15 or 3x20, local
supply).
Plotter
GD1700/1700C/1900C
Red
Soldering
Black
Cut other cables off, and wrap here with tape.
Connection of external buzzer and display unit
using cable assy type MJ-A7SPF0007-050 cable
Transducer
HUB (used when more
than two NavNet units
ETR-6/10N
are connected.)
MJ-A7SPF0007-050
Other
2-3