Page 1
• Easy ‘How to use’ guides for storage heaters • Service and repairs • Where to buy our products • Literature downloads • Heating requirement calculator Visit ‐ www.dimplex.co.uk/support A division of GDC Group Ltd Registered No: 1313016 England VAT GB 287 1315 50004 Millbrook House Grange Drive Hedge End Southampton SO30 2DF EEE Producer Registration Number –...
Page 6 Guarantee Page 12 Installing the Stove Page 6 SELBORNE 5 S SELBORNE 5 SE E E E SELBORNE 5 S SELBORNE 5 S GENERAL SAFETY NOTES SMOKE EXEMPT WOODBURNING STOVE • Properly installed, operated and maintained, this appliance will not emit fumes into the dwelling.
CAUSE REMEDY External wind conditions Fit stabiliser cowl. available from Dimplex that allows the stove to be installed further out of any building recess. Fig.1 shows suitable combined with chimney terminal Fit flue draught stabiliser. flue connections. IMPORTANT INSTALLATION NOTES: FLUE STABILISER The installation must allow for adequate chimney sweeping.
Fig. 4 – Arranging the flue outlet blanking plug for top or rear outlet OPERATING INSTRUCTIONS YOUR STOVE Fig. 5 shows stove and its controls. Top flue outlet collar Additional loose parts supplied inside your stove include: • A stove mitt – for removing the ash pan, adjusting the primary air controls, adjusting the airwash control, Rear flue collar and operating the door handle.
CORRECT RUNNING TEMPERATURE FOR BURNING RE-FUELLING Adding a ‘little fuel often’ is the best re-fuelling method to keep smoke to a minimum. Our tests have shown that To get the best results from your stove it is recommended that a wood stove thermometer (available from your stove burning logs not longer than 20cm and with a width or diameter of no more than 12cm will produce the optimum dealer) be fitted to the flue pipe above the stove, at eye level if possible.
............................................................................................................... HOW TO PROCEED WITH A COMPLAINT Your Dimplex Stove is guaranteed against defects rising from faulty manufacture for 1 year subject to the following ..................................... conditions. Failure to comply with these conditions will invalidate the guarantee: .....................................