Advertisement
ASSEMBLY INSTRUCTIONS
1) Assemble the detached base to the support pole using the screw provided. (Fig. 1)
2) Remove the blade locking nut (by turning it clockwise), then the locking nut (by
turning it anti-clockwise) from the motor shaft.
3) Place the rear guard into position. Ensure the rear guard fits onto the locking lugs
with the handle uppermost and tighten the locking nut firmly. (Fig2)
4) Mount the fan blade onto the motor shaft and tighten with the blade locking nut (Fig.
3) anticlockwise.
5) Press the rim of the front guard to attach with rear guard until both guards are
properly fitted (Fig.4). Secure both guards firmly by tightening the clip (Fig5).
(Fig. 1 – Detached base)
(Fig.2 – Locking lugs and locking nut)
(Fig. 3 – Spinner tightens anti-clockwise)
(Fig.4)
(Fig.5)
Advertisement
